thanospr
19-05-19, 15:12
Γεια σας
Προσπαθω να προγραμματισω εναν arm με το pickit 4 απο το MPLAB X IDE. Ενω αναγνωριζει την συσκευη μου βγαζει το παρακατω σφαλμα
Connecting to MPLAB PICkit 4...
Currently loaded versions:
Application version............00.04.15
Boot version...................01.00.00
Script version.................00.02.97
Script build number............117b21ad10
Target voltage detected
Target device ATSAMD21E18A found.
Device Revision Id = 0x3
Configuration memory will not be programmed because no configuration bits settings have been defined in your code. To program configuration memory, either define the settings in your code or use the Program Configuration Bits button on the configuration memory window.
Erasing...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x9ff
Verify failed. [ Pgm ] at 0x0, expected 0x20002470, got 0xffffffff
You have set the program speed to Normal. The circuit on your board may require you to slow the speed down. Please change the setting in the tool properties to low and try the operation again.
Programming did not complete
Μηπως ξερει κανεις τι κανω λαθος;
Προσπαθω να προγραμματισω εναν arm με το pickit 4 απο το MPLAB X IDE. Ενω αναγνωριζει την συσκευη μου βγαζει το παρακατω σφαλμα
Connecting to MPLAB PICkit 4...
Currently loaded versions:
Application version............00.04.15
Boot version...................01.00.00
Script version.................00.02.97
Script build number............117b21ad10
Target voltage detected
Target device ATSAMD21E18A found.
Device Revision Id = 0x3
Configuration memory will not be programmed because no configuration bits settings have been defined in your code. To program configuration memory, either define the settings in your code or use the Program Configuration Bits button on the configuration memory window.
Erasing...
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x9ff
Verify failed. [ Pgm ] at 0x0, expected 0x20002470, got 0xffffffff
You have set the program speed to Normal. The circuit on your board may require you to slow the speed down. Please change the setting in the tool properties to low and try the operation again.
Programming did not complete
Μηπως ξερει κανεις τι κανω λαθος;